Thinklogical Velocityrgb System-9, 10 and 12 Manual Instrukcja Użytkownika Pobierz pdf (Strona 18)

Revision D 13 December 2012

Some menu options may not be available on some models

Display Modifiable Description

*System

LS Connected NO An indication of the fiber status from the TX to RX.

TX Ctrl Name TX Only Name entered on TX unit is displayed on RX unit.

Load Defaults YES Loads factory default video configurations.

Store Values YES Store video configurations.

TX Control NO Revision of the TX control firmware.

RX Control NO Revision of the RX control firmware.

FPGA Version NO Revision of the FPGA code

Serial Number YES Serial Number of unit.

Aud Reset En YES Resets the audio sync circuitry

SFP Loss of Signal NO An indication of fiber status on the extender Receive

channel. Value =

0 if signal is received, 1 if signal is missing.

Debug Values YES Factory Use Only.

___________________________________________________________________________________________

______________

*DDC – To be implemented at a later date

DDC PROM Emula. Mode YES Options are Dynamic, Static and Passthru.

In Dynamic mode, the DDC of the monitor connected to the RX is

read and stored on the TX. The CPU is informed of a change in

DDC and the monitor is read. This is useful when the CPU can be

turned on without a connection to the RX. Static mode is used to

maintain the current DDC regardless of monitor changes at the

RX. Pass-thru acts as a wire between the TX and RX and no

emulation takes place.

Load Default DDC YES Loads the default EDID table into the TX and changes the

mode to

Static.

Acquire DDC YES Gets the EDID table from the monitor attached to the RX and

stores it

in the TX.

Force DDC mode YES Sets the EDID Video Input Signal Type to either analog or

digital.

* Video

VGA Connected No An indication of whether VGA video is input to the Vis TX

Resolution input No Active pixels x active lines vertical rate

Hor. Freq No Horizontal frequency

Auto Phase Yes Automatically adjust the Sampling Phase to the best setting

PLL Total Yes The total pixel count in one line. Consists of Horizontal active

pixels +

Horizontal blanking pixels

HSOUT Width Yes Horizontal sync (Hsync) of video, measured in pixels

DE Start Yes Horizontal back porch (Hpb) of video, measured in pixels

DE Width Yes Total active pixels in one line

Line Start Yes Vertical back porch (Vbp) + Vertical sync (Vsync) of video,

measured

in lines

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

Komentarze do niniejszej Instrukcji

Brak uwag

Thinklogical Velocityrgb System-9, 10 and 12 Manual Instrukcja Użytkownika Strona 18

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy monitoringu Thinklogical Velocityrgb System-9, 10 and 12 Manual